Choose a shape and enter its dimensions in millimetres: the tool instantly calculates the area, centroid, second moments of area, elastic and plastic moduli and radii of gyration, and draws the section to scale.

Assumptions

  • Eurocode 3 axes: y horizontal and z vertical, through the centroid.
  • IPE, HEA and HEB sections: nominal catalogue dimensions (EN 10365); area, second moments and plastic moduli calculated including root fillets, using the usual catalogue formulas.
  • Welded or solid sections: made of rectangles, without fillets or rounded corners.
  • Plastic moduli calculated about the plastic neutral axis, which divides the area into two equal halves.
  • Torsion constant: catalogue formula for rolled sections, approximate value otherwise (thin walls for open sections, Bredt’s formula for the box section).

Example

Welded I girder, 400 mm deep, 200 × 15 mm flanges, 10 mm web: the section displayed when the tool opens.

Area A
97 cm²
Iy
26,470 cm⁴
Wel,y
1,323 cm³
Wpl,y
1,497 cm³

The flanges, 62% of the area, carry 84% of Iy: the point of an I section. Plastic reserve: Wpl,y / Wel,y = 1.13.

Load this example into the tool

yzG200 mm
Section to scale; axes y and z through the centroid G.
Method, limits and references

The section is split into rectangles: area and centroid, second moments by the parallel axis theorem, elastic moduli at the extreme fibre, plastic moduli about the axis dividing the area into two halves. IPE, HEA and HEB sections are calculated with their root fillets.

Iy = Σ (b·h³/12 + A·d²) = 26,466 cm⁴; Wpl,y = Σ |A·d| = 1,497 cm³

Limits

  • Gross, homogeneous section: no holes, no class 4 effective section, no reinforced concrete.
  • Approximate torsion constant except for rolled sections; no warping constant Iw.
  • Classes and resistances: see the steel sections catalogue.

References: EN 1993-1-1 (§5.5, §6.2); EN 10365; handbook: sections.

Checks: exact formulas on simple shapes; five rolled sections compared with catalogues, maximum difference 0.04%.

Frequently asked questions

Elastic or plastic modulus: which one?

It depends on the section class (EN 1993-1-1 §5.5): plastic for classes 1 and 2, elastic for class 3. The steel sections catalogue gives the class for the chosen grade.

Why is the torsion constant “approximate”?

For an open section, It ≈ Σ b·t³/3 neglects the junctions between walls; the difference remains a few per cent. Rolled sections use the catalogue formula.

Do IPE or HEA values differ from the catalogues?

Very little: the difference does not exceed 0.04% on the reference sections, catalogues rounding their values.

See also

Preliminary design aids, provided for guidance only: they do not replace calculations prepared by an engineer. Found an error, have a suggestion? Write to us.